AKG MP 40 Instruction Manual download pdf (Page 14)

3 Setting Up

3.1 Powering

To power the PR 40 portable

receiver you can use the supplied 1.5 V

AAA size dry batteries or 1.5 V AAA size

rechargeable batteries (not supplied).

3.2 Inserting/Replacing and Testing

Batteries (Fig. 3)

1. Depress the snap hook on the battery

compartment lid (1).

2. Pull the battery compartment lid (1)

down to remove it from the receiver.

Important: The foam pad on the inside

of the battery compartment lid (1)

holds the batteries in place. Do not

remove the foam pad. If you do, the

batteries will not be held in place

securely and may cause a rattling

noise.

3. If there are dead or defective batte-

ries inside the battery compartment,

remove the batteries.

4. Insert the supplied or new batteries

(2) into the battery compartment as

shown in fig. 3.

5. Set the ON/ OFF switch (3) to ON.

If the batteries are in good condition,

the BATT LED (4) will light green. If

the BATT LED (4) illuminates red, the

batteries will be dead within about 60

minutes. Replace the batteries with

new ones as soon as possible.

If the BATT LED (4) fails to illuminate

the batteries are dead. Insert new

batteries.

6. Slide the battery compartment lid (1)

onto the receiver against the direc-

tion of the arrow to the point that the

lid (1) will click shut.

14

Fig. 3: Inserting batteries.











1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 51 52

Comments to this Manuals

No comments