AKG IVM4500 Specifications download pdf (Page 28)

2 Description

Display

Fig. 2: LC display on

ransmitter front panel.

Refer to fig. 2.

Rear Panel

Fig. 3: Inputs and outputs

on transmitter rear panel.

Refer to fig. 3.

SPR 4500

Bodypack Receiver

Controls

Refer to fig. 4.

The display indicates all operating parameters of the transmitter:

Compressor and limiter gain reduction.

2 Menus for frequency, transmitter name, input gain, audio processing, system

settings.

3 Submenus for Frequency Group, Subchannel, RF output.

4 OFF (red): Indicates the transmitter is off the air.

5 LOCK mode label (red): goes out in SETUP mode.

6 Alphanumeric display.

7 Audio input level bargraph and red PEAK LED

8 Audio functions: input mode, highpass filter, EQ, room simulation, compressor,

bypass.

In SETUP mode, the currently active setup parameter will be flashing.

1 ANTENNA: BNC antenna output.

2 AUDIO LOOP L/CH1, R/CH2: These two jacks are connected in parallel to the

AUDIO IN jacks and carry the unprocessed input signal.

3 AUDIO IN L/CH1/MONO, R/CH2: Combined female XLR/1/4" jacks for feed-

ing in a stereo or mono signal. The ?" jacks accept both balanced and unbal-

anced cables.

4 LINE OUT STEREO: This TRS ?" jack provides the processed audio signal. You

can feed this signal to an extra monitor amplifier for floor wedges, etc.

5 DC ONLY: Locking DC input for connecting the included power supply.

6 DATA: Interface for linking the transmitter to a HiQNet network for controlling the

transmitter using a computer and HUB 4000 Q.

The SPR 4500 bodypack receiver has been designed specifically for use with the

SST 4500 transmitter and IP 2 earbuds. You may, however, connect other earbuds

to the receiver as well.

To power the receiver you can use either the two supplied dry batteries or the op-

tional BP 4000 battery pack from AKG.

1 Headphones output: TRS mini jack.

2 Detented rotary control with integrated on/off switch: Switches power to

the receiver on and OFF and sets the volume of the earbud signal.

3 Permanently attached flexible antennas.

4 Status LED

IVM

4500

12 64 53

2 3 4

BDA_IVM4500_120311_Kern_final:Layout 1 05.06.2012 12:28 Uhr Seite 28

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 124 125

Comments to this Manuals

No comments

AKG IVM4500 Specifications Page 28

Comments to this Manuals

Related products and manuals for Routers AKG IVM4500