AKG IVM4500 Specifications download pdf (Page 30)

3 Setting Up

Important!

lacing the

Transmitter

Rack Mounting the

Transmitter

Rack Mounting a Single

Transmitter

Refer to fig. 7.

Rack Mounting

Two Transmitters

Side by Side

Refer to fig. 8.

• Prior to every soundcheck, verify that the transmitter and receiver are

uned to the same frequency.

eflections off metal parts, walls, ceilings, etc. or the shadow effects of musicians

and other people may weaken or cancel the direct transmitter signal.

For best results, place the transmitter or remote antenna as follows:

1. Place the transmitter/antenna near the performance area (stage). Make sure,

hough, that the receiver will never get any closer to the transmitter than 10 ft

(3 m). Optimum separation is 16 ft. (5 m).

. Place the transmitter/antenna at least 5 ft. (1.5 m) away from any big metal ob-

jects, walls, scaffolding, ceilings, etc.

3. Place the transmitter at least 10 ft. (3 m) away from any wireless microphone re-

eiver (e.g., an SR 4500) in order to prevent crosstalk from the in-ear monitor

system into wireless microphone channels.

1. Unscrew the four rubber feet (1) from the transmitter bottom panel.

2. Unscrew the two fixing screws (2) from each side panel.

3. Use the fixing screws (2) to screw the short bracket (3) to one side panel and the

long bracket (4) to the other side panel. The brackets are contained in the sup-

plied rack mounting kit.

4. Install the transmitter in your rack.

1. Unscrew the four rubber feet (1) from each transmitter's bottom panel and re-

move the screws (5) from the rubber feet (1).

2. Unscrew the two fixing screws (2) from the right-hand side panel of one trans-

mitter and from the left-hand side panel of the other transmitter.

3. Insert one connecting strip (4) into each free slot in the side panel of the first

transmitter, making sure to align the hole in each connecting strip (4) with the ap-

propriate threaded hole in the transmitter bottom panel.

4. Fix the three connecting strips (4) on the first transmitter using three of the

screws (5) you removed from the rubber feet.

5. To join the two transmitters, slide the connecting strips (4) on the first transmit-

ter through the free slots in the side panel of the second transmitter. Make sure

to align the hole in each connecting strip (4) with the appropriate threaded hole

in the bottom panel of the second transmitter.

6. Fix the connecting strips (4) on the second transmitter using the three screws

(5) you removed from the rubber feet.

7. Screw a short bracket (6) to the outer side panel of each transmitter using for

each bracket two of the screws (2) you removed from the transmitter side pan-

els.

8. Install the transmitters in your rack.

IVM

4500

BDA_IVM4500_120311_Kern_final:Layout 1 05.06.2012 12:28 Uhr Seite 30

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 124 125

Comments to this Manuals

No comments

AKG IVM4500 Specifications Page 30

Comments to this Manuals

Related products and manuals for Routers AKG IVM4500