AKG IVM4500 Specifications download pdf (Page 33)

3 Setting Up

Setting Up the

Transmitter

mportant!

ntenna

Important!

udio Connections

Note:

Mono Monitor Signal:

Note:

Stereo Monitor Signal:

Two Independent

Monitor Signals:

AUDIO LOOP:

See section

"EXTRA/MODE".

See section

"EXTRA/MODE".

LINE OUT STEREO:

• To avoid the risk of electric shock, install the antenna and make all audio

onnections before connecting the transmitter to power.

• Connect the supplied rod antenna to the ANTENNA socket on the transmitter

rear panel and lock the BNC connector.

• If you use a remote antenna, please note that these antennas may boost

heir RF output (ERP) in their preferred directions. In order to keep RF out-

put within legal limits, make sure to use antenna cables of the correct

ength for each type of cable, e.g., RG58: 16 ft. (5 m) for an RA 4000 W or

33 ft. (10 m) for an SRA 2 W.

• The AUDIO IN sockets accept both XLR connectors and 1/4" jack plugs.

• If only a single mono monitor signal is available, e.g. at an AUX output, connect

the appropriate output on your mixer to the L/CH1/MONO jack on the transmit-

ter rear panel.

• Mono signals will not be transmitted in mono unless the room simulator is de-

activated. (The room simulator will generate a stereo signal from any mono input

signal.)

• Connect the stereo monitor outputs on your mixer to the two AUDIO IN jacks

on the transmitter rear panel.

• If your mixer can provide two different monitor signals (e.g., AUX 1 for the

soloist's microphone and keyboard, AUX 2 for the entire band), connect AUX 1

to L/CH1/MONO and AUX 2 to R/CH 2.

The AUDIO LOOP outputs carry the unprocessed audio input signal. You can use

these outputs as follows:

A (refer to fig. 11):

You can feed the same stereo monitor signal to one or more SST 4500 transmitters.

This allows you to set the sound, compression, etc. individually for each musician.

Fig. 11 shows a wiring example.

1. Connect the stereo monitor outputs on your mixer to the two AUDIO IN jacks

on the rear panel of the first transmitter.

2. Connect the AUDIO LOOP jacks on the first transmitter to the AUDIO IN jacks

on the next transmitter.

3. Repeat step 2 for all other transmitters.

4. Set all transmitters to STEREO mode.

B (refer to fig. 12):

You can use one channel to distribute the same mono monitor mix to several

SST 4s while feeding a personalized monitor signal for each musician to the other

input channel on each SST 4500. This allows each musician to set their own bal-

ance between the two signals on the receiver. Fig. 12 shows a wiring example.

1. Set all transmitters and receivers to DUAL mode.

2. Explain to the musicians how to set the balance between the band mix and their

own signals on the receiver.

C – other applications:

You can also feed the AUDIO LOOP signal to a separate amplifier for stage moni-

tors, a headphone amplifier, or a recording device.

LINE OUT STEREO is an alternative output for connecting a headphone amplifier

or recording device. This jack carries the processed audio signal.

IVM

4500

BDA_IVM4500_120311_Kern_final:Layout 1 05.06.2012 12:28 Uhr Seite 33

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 124 125

Comments to this Manuals

No comments

AKG IVM4500 Specifications Page 33

Comments to this Manuals

Related products and manuals for Routers AKG IVM4500