AKG IVM4500 Specifications download pdf (Page 34)

3 Setting Up

Connecting to Power

mportant!

Setting Up

(

LOCK/SETUP Modes)

LOCK Mode:

SETUP Mode:

Selecting Modes:

Deactivating

the RF Output

Selecting

Frequencies from the

Preset Screen

Selecting

Frequencies from the

Frequency Screen

Naming the Transmitter

Setting Input Gain

Multichannel Systems

Important!

• Check that the AC mains voltage stated on the included power supply is

dentical to the AC mains voltage available where you will use your sys-

tem. Using the power supply with a different AC voltage may cause dam-

ge to the unit.

1. Plug the feeder cable on the included power supply into the DC ONLY socket

n the transmitter rear panel and screw down the DC connector.

2. Plug the power cable on the power supply into a convenient power outlet.

• The transmitter will automatically come on in LOCK mode.

The transmitter is electronically locked so you cannot make any adjustments. The

red "LOCK" label is lit on the display.

• You can scroll through the following status screens:

- Preset (comes up only if a Preset has been saved): Carrier frequency shown

as a Subchannel number within a Frequency Group.

- Frequency: Carrier frequency in MHz. (This screen is always available, even

if no Preset has been saved.)

- "DEVICE NAME": Current receiver name (comes up only if you have previ-

ously named the receiver)

In SETUP mode, the electronic lock is disabled so you can adjust all transmitter

parameters. The "LOCK" label disappears.

• To toggle between LOCK and SETUP modes, hold down SETUP for about

2 seconds.

• Hold down the RF ON/OFF control for about 2 seconds.

1. Switch the transmitter to SETUP mode.

2. If the display shows the frequency in MHz, briefly turn SETUP CCW to call up

the Preset screen.

3. Select a Frequency Group ("GROUP") and a frequency ("CHANNEL") within this

Group.

4. Set RF output to the desired level between 10 mW and 100 mW. Make sure to

comply with RF output limits as required by local law!

You can use the RF ON/OFF key to deactivate the RF output.

5. Save your setting ("SAVE—Y").

1. Switch the transmitter to SETUP mode.

2. If the display shows the Preset screen, briefly turn SETUP CCW to call up the

frequency screen.

3. You can select the frequency in 25 kHz increments.

4. Set RF output to the desired level between 10 mW and 100 mW. Make sure to

comply with local RF output limits!

You can use the RF ON/OFF key to deactivate the RF output.

5. Save your setting ("SAVE—Y").

• You can use the "DEVICE NAME" screen to assign a name to the transmitter.

• The control range is -20 dB to +20 dB.

• To save the selected value, press SETUP briefly.

• Do not operate two or more wireless channels on the same frequency at

the same time and location. This would cause unwanted noise due to radio

interference.

1. Select the same "GROUP" on all transmitters and receivers.

IVM

4500

BDA_IVM4500_120311_Kern_final:Layout 1 05.06.2012 12:28 Uhr Seite 34

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 124 125

Comments to this Manuals

No comments

AKG IVM4500 Specifications Page 34

Comments to this Manuals

Related products and manuals for Routers AKG IVM4500